I had a leak in the Pressure Switch (6 years old) though it was working, it leaked. I replaced it
with a new switch and now the water pump will not cut off. I have to use the circuit breaker to
control the pump. I built it up to 45 PSI (20 - 40) and noticed over a 60 minute period it lost all pressure.
Though no noticeable leak. Because I replaced the switch the holding tank drained down to the level of the switch, about half the tank. Is there more to this process then simply replacing the switch? I have adjusted the cut out nut but doesn't seem to matter. Thanks Phil
with a new switch and now the water pump will not cut off. I have to use the circuit breaker to
control the pump. I built it up to 45 PSI (20 - 40) and noticed over a 60 minute period it lost all pressure.
Though no noticeable leak. Because I replaced the switch the holding tank drained down to the level of the switch, about half the tank. Is there more to this process then simply replacing the switch? I have adjusted the cut out nut but doesn't seem to matter. Thanks Phil